Utilisateur

On a 2015 Toyota Corolla LE (non-push-to-start) is there a benefit of using THAR-ONE-TOY8 over THAR-ONE-TOY3?

We have had some issues finding the Immobiliser Data wire in a 2017 PTS Subaru WRX STI, the install guide tells us it is plug B pin 25 behind the glove box in the ECU, The ECU in this car does not have a wire in that location!, after many emails and many phone calls i was finally able to get a pinout diagram for the exact ECU in that car and it would seem the Immobilser data wire is in a different plug and different location (Still in the ECU behind the glovebox though) if we cut it the car starts for 2 seconds then dies also the key lock light on the dash illuminates, but when we wire it up to the EVO-ALL it won't read the data, we just get steady Red Blue Lights instead of the 10 red and 10 blue flashes, we can use the EVO-ALL for convienence features but not Immobiliser bypass, does anyone have any ideas or have seen this on any other subaru's using different software all help would be appreciated. Plug B "Pin 25" is the one shown in all the install guides which isn't populated in our ECU and Plug C "Pin 26" is the one shown in the Pinout diagram from Subaru. Hopefully everyone can follow my Question/Diagram!!!!

2019 Ram 1500 push to start Unable to get past step 6 blue led will not stop flashing when Start/Stop button is pressed to turn off ignition.

VIN: 1C6RREFT6KN568083

Hardware version is 6.0  

Firmware version is 63.[01]  

flash limit 2/8  

Have tested contunity on all leads for completeness, wires are in the correct place and not incorectly tied.  

Flash Link  

Hardware version 4.0  

Firmware version 4.[05]

I have tried pressing unlock on oem remote when blue is flashing and ignition is off.

Outcome: Truck responds by unlocking doors and blue led is still flashing rapidly.  

I have tried resetting the unit and attempted to program. I also toggled push to start on and attempted to program as well.

Outcome: I am still Unable to get past step 6 blue led will not stop flashing when Start/Stop button is pressed to turn off ignition.

I am still unable to get past step 6.

Fortin, what are the proper channels I can use to esclate this matter further. It has been several months of back and forth with no progress. I feel the only other way to get through to you would be by sharing my emabrising expierence on social media platforms. Before I do let me ask one last time...please help. 

Best,

Dylan Davila